Re-run Unfinished/Error Points Problem

I had a license server failure with 12/193 runs not finishing. When I try to use the 'Re-run Unfinished/Error Points' option in the Assembler history the tool attempts to run all 193 points instead of the 12 that reported 'sim err' in the results. I've not experienced this behavior in the past. I found the following articles:

https://support.cadence.com/apex/ArticleAttachmentPortal?id=a1O0V000006D7z8UAC&pageName=ArticleContent

I'm not using the Reference History option (it's grayed out).

https://support.cadence.com/apex/ArticleAttachmentPortal?id=a1Od0000000vR4UEAU&pageName=ArticleContent

I've also tried setting the evalOutputsOnSimFailure environment variable to 'None' as suggested here.

Any other suggestions on what to check to see why this is trying to run all points again? Thanks.