alter option

Hello,

Before running my transient simulations, I want to change the multiplicity factor of some blocks. ( I am using  spectre / spectreXps )

I use the command lines below. Does the simulator change the multiplicity of each block, then run the simulations. Or, it takes only the first (or last) line ? If it is the case what should I write to make the simulator make all changes at once then run.  ?

Thanks,

Kotb

Loadmimic0 alter sub=X8SEG\<0\>.XSEG\<7\> param=m value=4
Loadmimic1 alter sub=X8SEG\<0\>.XSEG\<0\> param=m value=2
Loadmimic2 alter sub=X8SEG\<1\>.XSEG\<7\> param=m value=6 
Loadmimic3 alter sub=X8SEG\<1\>.XSEG\<0\> param=m value=8

tran tran stop=1000n step=100p