Hello,
I am sure this has come up before but couldn't find it on the forums.
The query is relating to the properties of a VerilogA block. When the block is placed in a schematic and the properties are viewed (using Q) the default “CDF parameter of View” comes up as “Use Tools Filter” which does not show the parameters in the Verilog code (see Fig.1) . It is only after clicking on the view “veriloga” that the parameters can be seen (Fig.2).
Only an inconvenience but I was wondering if there is a way the CDF Parameter of view can be set such that it searches for "veriloga" rather than the current default which is "Use Tools Filter"?
Many thanks, Chris.
