Hi,
I am using Virtuoso XL for my layout. The abutment sever as well as auto abutment are enabled in it. When I abut the existing Pcells, let's say 2 PMOS devices like below, abutment works just fine.
When I check against the source (schemaitc), I can see following messages :
INFO (LX-1005): Parameter 'rightAbut' is set to '0' on schematic instance 'PM11' but is '3' on layout instance '|PM11'.
INFO (LX-1005): Parameter 'rightAbut' is set to '0' on schematic instance 'PM6' but is '5' on layout instance '|PM6'.
(I usually update the schematic components later to match layout and schematic)
However when I connect the abutted contact to another (similar) node, the yellow box appears on the abutted contact. What is the reason for that ?
Thanks
Ranaya