We have a situation where a single resistor device is placed in a schematic. Then in layout, the designer segmented the resistor into two series resistors. The device has a CDF parameter called "Segments" which has been set to 2.
LVS is clean and we can extract a DSPF via Cadence QRC.
When the DSPF is then ran in Specter sim, we do not get 100% back annotation because the Spice NL from the schematic does not contain the extra resistor and series Net present in the DSPF.
Has anyone ran into this issue? If so how did you resolve it without post processing the DSPF?
Shane.