[ Used version : Virtuoso IC618 ]
I'm currently trying to simulate a parametric set with ADE XL, but I'm having a problem.
I understood how to create a parametric set in ADE XL through help documents and articles in the forum, and I tried to create a parametric set using 9 variables like under figure.
In this case, I thought I could create a total of 8 parametric sets as shown below.
Variable order : iswing s1 s2 s3 s4 s5 s6 s7 s8
SET1 = 1.6m 1 0 0 0 0 0 0 0
SET2 = 800u 0 1 0 0 0 0 0 0
SET3 = 400u 0 0 1 0 0 0 0 0
SET4 = 200u 0 0 0 1 0 0 0 0
SET5 = 100u 0 0 0 0 1 0 0 0
SET6 = 50u 0 0 0 0 0 1 0 0
SET7 = 25u 0 0 0 0 0 0 1 0
SET8 = 12.5u 0 0 0 0 0 0 0 1
When run simulation, the following error message(ADEXL-2343) is shown for variables s1 - s7.
To check if I understood exactly how to make a parametric set in ADE XL, I tried to make a parametric set using two variables as shown in the help document, but no error was shown. This problem always occurs when I simulate more than 3 parametric sets. (The number of variables was not related to the error.)
Please let me know if you have any problems with my simulation setup.
Thanks for reading.