Dear All;
I need to run multiple spectre simulations from MATLAB (using system() command to fire transient simulations) as I need to modify the netlist for changing some parameters of the circuit in the schematic.
Also, there is a need to plot the waveforms in ViVa after the end of each simulation run.
"spectre /../input.scs" command run the transient simulation but it doesn't plot the waveforms
I tried to use the corresponding oceanScript.ocn by using the command "ocean -replay /../oceanScript.ocn". This plotted the waveforms in ViVA. But there is no exit from the terminal after the end of simulation.
I then manually entered the above command in the terminal (without using system() from MATLAB).
I saw that after simulation it stays as below after pressing ENTER key:-
Can anybody please tell how to overcome the issue.