Hi,
e.g. I can get voltage noise vs frequency directly from noise analysis, but I could also run transient, and make a dft or psd plot. Now I want to overlay them, but ADE or ViVA defaults prevent a direct plot into the same plot.
I need to do "Allow any units" on the x-axis and also to select a common y-axis (out of the existing ones).
This is quite some manual work, and the lack of convenient automatic plotting makes also automatic datasheet generation difficult.
Is there a cdsenv setting to allow any units by default? And is there an option to influence whether ADE creates a new y-axis or if y-axis are shared?
Bye Stephan