Hi,
I know I can go back via Load setup to active.
However, now this has happened: I run a somewhat modified transient noisie analysis in a test, and see it is now much slower than before. So I expect a minor difference like saving too much data or changes on reltol, etc.
However, in the history tab I see only the tests itselfs, but not details like the older analysis setup or the used netlists.
Is there a good way to compare two test setups? For me it looks that I need to wait for some hours till the current simulation stops, and then to compare via Load setup to active and eye inspections.
However, isn't there a more elegant way?
Bye Stephan