AC Sim Output Setup Issues

Hi,

I have the following setup defined in my outputs.

After the simulation, I can see the "AC CL Gain" but nothing is seen for "AC CL Gain at 10kHz".

Both the outputs are shown as plots. Any comments on why this might be happening?

Also, when I include these outputs in the montecarlo simulation, I dont see the "10 KHz value" listed in the variations. I have dc parameters in there that seem to be ok. This may be because the "10 KHz Value" appears as a "plot" and not a "value". Any suggestions on how to get the "value" and not the "plot"?

Thanks much!