Measurement across Corners/Sweeps/All in ADE Assembler

Hello,

I am using Cadence Virtuoso version IC6.1.8-64b.500.6

I am running some calculations at the result of specific corner. for example, I am calculating the average current at the output of a resistor resulting from temperature change from -40 to 85 °C and at a specific process corner.

I do this by introducing an expression to th ADE Assembler output setup and changing the EvalType to "ALL"

Up to this point, I have had no issue 

However, if I add a second corner, the average current will be the average of the output from corner 1 and 2, while my target is to have the average of each individually

I hope I made the status clear

thank you in advance

Regards