Layout Netlist and Topcell Netlist shows correct connections but LVS does not pass!!!

Hi,

I  am generating the topcel netlist from schematic and layout netlist from layout. I have checked both of them. Topcell netlist has an "X" before each component name which I should eliminate them manually to check the LVS. Netlists show correct connections in the layout but the LVS gives me error and even it says that I have no pins and even the number of nodes are not matched. I have designed a simple voltgae divider and did the layout to make sure whether the problem is with my Cadence or not. But it did not work, too. I have attached my Schematic, Layout and netlists. Please help me since the deadline is so close to me.

Regards,

Mehdi

Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.

  Error:    Different numbers of ports (see below).
  Error:    Different numbers of nets (see below).
  Error:    Different numbers of instances (see below).
  Error:    Connectivity errors.

LAYOUT CELL NAME:         test
SOURCE CELL NAME:         test

--------------------------------------------------------------------------------------------------------------

INITIAL NUMBERS OF OBJECTS
--------------------------

                Layout    Source         Component Type
                ------    ------         --------------
 Ports:              0         3    *

 Nets:               3         3

 Instances:          0         2    *    R (2 pins)
                     2         0    *    rppolyl (2 pins)
                ------    ------
 Total Inst:         2         2


NUMBERS OF OBJECTS AFTER TRANSFORMATION
---------------------------------------

                Layout    Source         Component Type
                ------    ------         --------------
 Ports:              0         3    *

 Nets:               2         3    *

 Instances:          0         2    *    R (2 pins)
                     1         0    *    rppolyl (2 pins)
                ------    ------
 Total Inst:         1         2


       * = Number of objects in layout different from number in source.



**************************************************************************************************************
                               INFORMATION AND WARNINGS
**************************************************************************************************************


                  Matched    Matched    Unmatched    Unmatched    Component
                   Layout     Source       Layout       Source    Type
                  -------    -------    ---------    ---------    ---------
   Ports:               0          0            0            3

   Nets:                0          0            2            3

   Instances:           0          0            0            2    R(RPPOLYL)
                        0          0            1            0    rppolyl
                  -------    -------    ---------    ---------
   Total Inst:          0          0            1            2


o Statistics:

   2 series layout resistors were reduced to 1.  1 connecting net was deleted.

Image may be NSFW.
Clik here to view.