Annotation does not work however, Print DC operating point works fine - ISSUE

Hi,

So when I'm using an instance N_12_LLHVTRF (mosfet) from the umc65ll library, the annotation of the DC operating point does not work on the component. However, when I use the print dc operating points, then all the parameters are displayed. I am not sure on why this discrepancy is occuring. Due to this I am unable to sweep any dc op parameters, and I have to manually do the print dc operating point for every simulation, and this is becoming time consuming. (attached screenshots)

Cadence version - IC6.1.7-64b.78

Please do help, if anyone has had this issue previously.

Thank you so much.

Avinash