I'm slowly getting back into design mode after many months in layout and seem to have forgotten a detail of a feature I put into my schematics to annotate device operating points and bias currents in various legs of my circuit. I run all of my sims in ocean from the CIW and within that world I configure my sim through various variables and end up sticking the results into a directory defined by:
resultsDir(strcat(defaultpath "/" corner_name "/" "test_type_" desVar("test_type")))
The sim runs and plots stuff via my plot commands and then, as I recall, I would just go to my schematics and (after a pesky redraw to flash out all the "nil" annotations) see all my transient sim annotations update with the sim results. I do recall having to set up which annotations needed to be viewed beforehand through the View->Annotations menu, but I don't recall having to manually keep the annotations simulations results directory in sync with my ocean script via the View->Annotations->Setup menu item as I changed my PVT corner type. Was/Is there a dynamic way for an ocean script to update the simulations results directory for the annotations in the schematics world?
