Hello,
I'm modeling a PCB trace using rfTlineLib components, and wanted to clarify a couple things about "sbend" discontinuity in particular.
1. Documentation for this component in Cadence does not provide any indication re: how the angle is defined. I found an older ADS sbend model here (https://edadocs.software.keysight.com/pages/viewpage.action?pageId=5906296), which states direction of angle for positive/negative numbers. Can I assume it's same for the sbend in rfTlineLib?
2. Documentation also indicates that I should be able to specify negative angles, but every time I enter a negative number for the angle in the properties, it defaults immediately to 90deg... is this behavior expected?
Many thanks in advance,
David