I am running Transient Analysis and usually after running it for some time (not finished yet) I can plot some signals from Direct Plot --> Transient Signal. However, sometimes I get a problem, at some time it plots but stop update the signals after that. For example, if I run the analysis for 1 milisecond and at 250u seconds I can plot the signals. However, for some reason it doesn't update more even the analysis already runs up to 800u seconds. I have to wait for the transient analysis to finish or stop it to see the signals.
What's the problem with it?
Is there some method to fix this?
↧
Direct Plot then Transient Signal stop updating after some time
↧