I'm using ICADV12.3-64b.500.21 with Calibre interactive v2018.4_25.17.
From the schematic view it is easy to perform (parameterized) sweeps of device parameters and do simulations.
I would like to do the same with the layout and an extraction simulation (using Calibre xACT).
The layout is already suitable, such that when the parameters are changed, the connecting wires and pins are still correct.
Any advice on how to get this done would be nice.
The first problem is that the layout does not accept variables. Should I generate a bunch of layouts with the different parameter values to over come this? Is there a way such that I don't have to generate them all manually?
And once that is tackled, is there a way to simulate the whole set of generated extraction cell views in one go?
Thank you,
Emiel