Hi,
I wonder how I can save the DC operating points in the output window and have the valued displayed after I run simulations for different corners.
When I use ADE, after the DC sim, I can choose "Annotate - DC operating points", then the net voltage will be displayed in the schematic. Is there a way I can put a certain net voltage into the output window so that the results will be displayed automatically after the simulation is done?
I need to check some voltage and current over different corners, so I'll need to add them into the outputs.
I tried to put OP("/xxx" "i") in the output, but it does not do anything.
Any help is appreciated. Thank you very much!