Hi,
I managed to get e.g. Vdsat or Vdsat_margin from the pure DC Operating point.
For this I used the results browser to get the required calculator expression, and and up in this output:
pv("DUT.Catena.Ampli.ItoV.opaLV.M18.m1" "vsat_marg" ?result "dcOpInfo")
However, actutally I setup a whole DC sweep on input current, so I want not only a single output value like 540mV, but a plot how Vdsat_margin behaves vs Iinput.
How to achieve this? I think I need to extend the save statement in some way. In the DC analysis setup I found no suited entry fields so far and using the option enable_dcsweep_op_info=yes seems not to help as well.
Bye Stephan