Hello,
I am running a transient simulation for ADC ENOB calculation purposes. In Spectre, there is an option called "strobeoutput" which I set to "all" to force the transient simulation to calculate the desired periodic points avoiding FFT interpolation errors, and at the same time calculate the necessary points needed for simulation accuracy requirements.
However, on simulating a Verilog model with AMS simulator, I can't find "stobeoutput" option. Is there a way to enable this option and set it to "all"?
Virtuoso: IC6.1.8-64b.500.15
Spectre: 19.1.0.541.isr14
xrun 19.09-s016
Kindest Regards,
Nader Fathy