Changing the parameter inside model file for creating multiple corner cases.

Hi All,

I wish to seeks some advise on performing multiple simulations using ADE-XL. I have to vary a parameter inside the model file whose value changes from 1 to 5. It is a switch provided inside the model file.

Is there a way to add these 5 cases (i.e. changing the value of the switch from 1 to 5) as corners inside ADE-XL so as to simulate all these 5 cases in one go ?

My present corner setup looks as shown below with 9 corners already setup. I need to simulate the above 5 cases at each of these 9 corners i.e. I need to change the value of the switch from 1 to 5 inside the model file at each of the below 9 corners.

Any hints will be great help.

regards