I have a fuse circuit with an efuse element that has a CDF Parameter called "value of fuse" where you can put the resistance of the efuse. In the past I have had a seperate schematic for blown fuses and un-blown fuses. I set the un-blown fuses to FUSE0 and the blown fuses to FUSE1. Then I instantiate the circuits with the blown fuses where I need them. In ADE-L I set the value of FUSE0 to a low value and FUSE1 to a high value.
What I'd really like to do is just have one fuse circuit and pass FUSE0 or FUSE1 into the symbols similar to how I might do a netset.
How do I set this up? In the symbol for the efuse I changed the value of the fuse to FUSEVAL, but I haven't found the right place in the fuse circuit symbol to equate FUSEVAL with FUSE0 or FUSE1.
Thanks, Chris