I am using ade-xl/assembler in IC6.1.8-64b.500.14.
My question is about click the yellow button of "re-evaluates using current setting from outputs setup table or with partial simulation data". There are two cases that I need help to have this button work properly.
Situation 1: my simulation failed for somereason (disk full and hence the table shows the simulation status is "running") and hence I use the command under netlist/runSimulation to re-run the simulation in linux terminal(after disk is cleaned), but the button in ade-xl/assembler cannot reflect the latest data after the correct simulation is done (the table box sitll shows "running"). How can I have the ade-xl/assembler to refelct the updated data from psfxl files?
Situation 2: I have a skill code updated (using "load" command in CIW) for calculator expression and then click the yellow button, want to have the table in ade-xl/assembler to reflect my latest skill code changes, but the evaluation fails or keeps the old skill code results. I have to re-run the simulation in ade-xl/assembler to have the table updated. How can I avoid re-run the simulation to have the data updated correctly in the table?
In both above cases, How can I make this ade-xl/assembler table in results tab work instead of re-run a new round of simulation?
Regards
monglebest