I would like to ask about moving text for pin names in my symbol.
As you can see in the figure, there are two OPAMP symbols. One is mine and the other is from other person and I copied them to the same schematic.
However, as you can see for pin names like Vin+ and Vin-, in my OPAMP symbol I couldn't fine move and put it symmetric in the middle like the one on the right.
I put two OPAMP symbols on the same schematic and check all properties of text, they're same. However, the one made by other can fine move (not sure if this is the right term, I meant move with small resolution or something like that) but mine can not.
I think I can do by changing grid resolution but that doesn't seem to be the root cause because the OPAMP made by other just fine move perfectly well with the same setting.
(the length of wire segments for pins are also same)
